eBay:n kautta ostin omani tältä myyjältä -> http://bit.ly/bg45FA Aparaatti tuli FedEx:n toimittamana eli kyseinen kuriirifirma hoitaa myös tullihuolinnan
Suosittelemme:
Radiomarket.fi
Tämä jakso sallii sinun katsoa tämän jäsenen kaikkia viestejä. Huomaa, että näet vain niiden alueiden viestit, joihin sinulla on nyt pääsy.
Näytä viestit MenuLainaus käyttäjältä: JTK - 25.05.2010 - 11:32
PS Huom JJH: näitä vastaavia asemalistoja voisi kerätä fmdx.tk:ssa omalle sivulleen! Mulla on favoriteissa monta maata valmiina... :-)
Lainaa
Two brief points about the tuning steps and the RDS decoding:
The 100kHz tuning step is felt to be a weak point for dx-ing, and it would be nice to try it with smaller steps. I tried using a signal generator to replace the internal master clock signal, and the results were not noticeably useful. A 50kHz step would be pointless as neither adjacent channel is received, but a step of 10 or 25kHz from nominal does reduce strong adjacent-channel qrm slightly. Shifting the internal clock frequency by ±10kHz is not practical so we'll have to live with 100kHz steps. All demodulation and data decoding is done in the DSP chip, so the RDS data stream is not directly available for external decoding with the normal software. The pin connection marked 'RDS' on the PCB is just a timing signal for the front-panel display. However the RDS data is available on the I²C microcontoller bus, as reported by Brian Beezley. It is possible to extract the RDS data from the bus, and Olivier Guillaume has successfully done so and extracted the PI + PS codes and the S-meter data, for the benefit of Global Tuners operators who run an XDR